Material List

Transmitter:

• 1- ATmega163 40 pin DIP IC
• 1-UHF TRX 433 MHz (Radio Shack UHF Module)
• 1-7805 V Regulator
• 1- 4Mhz Crystal
• 1- Red LED
• 1- Green LED
• 1- Double Row Pin Header (Firmware Upgrades)
• 2- 0.01uF Electrolytic Caps
• 2- 33 pF Ceramic Caps
• 3- 120 pF Ceramic Caps
• 2- 1.5 kOhm Resistors (LED)
• 1- 433 MHz Antenna from RFDigital.com
• 1- 1uF Electrolytic Cap
• 1- 18 Ohm Resistor (3dB pad)
• 2- 295 Ohm Resistor (3dB pad)
• 5 – Resistive Flex Sensors (Nintendo Power Glove)
• 5- Resistors (Depend on the value of the Flex Sensors)
• 1- Pack of extra caps (ceramic and electrolytic)
• 1- Pack of extra resistors
• 1- Pack of wires (jumpers)
• 1- Pack of Zip ties
• 1- Pack of LED clips
• 1- Pack of ferrite beads
• 1- 6 X 2 X 1.5 enclosure
• 1- Section of shielded cable
• 1- PCB Board Kit
• 1- Small SPST sliding switch
• 1- Pack of 9V batteries
• 1- 9V battery Clip
• 1- 9V battery harness
• 1 – Arm strap (To strap enclosure to your arm)

Receiver:

(Some components may be duplicated from TRX list)

• 1- 433 MHz Receiver (Radio Shack UHF Module)
• 1- Green LED with 1KOhm Resistor
• 1- Red LED with 1KOhm Resistor
• 1- MAX232 Line driver IC
• 4- 1uF Electrolytic Caps
• 3- 0.01uF Electrolytic Caps
• 2- 10uF Electrolytic Caps
• 1- 18 Ohm Resistor (3dB pad)
• 2 – 295 Ohm Resistor (3dB pad)
• 1- 1KOhm Resistor
• 1- 1 Meg Resistor
• 1- 433 MHz Antenna (RFDigital.com)
• 1- Serial Cable
• 1- 7805 V Regulator
• 1- 9V Power Module (Plug in module for Voltage Source)
• 1- Toggle Switch
• 2- LED holders
• 1- Power Jack for plug in module
• 1- 4.5 X 2.5 X 1.5 Enclosure
• 1- Pack of wires
• 1- Pack of Zip Ties
• 1- Pack of rubber feet
• 1- Pack of extra caps (ceramic and electrolytic)
• 1- PCB Board Kit

Tools:

• Oscope
• Soldering Iron
• Dremel with attachments
• Hack Saw
• Mini Vise
• ATmega Programmer-STK500
• Desktop PC

& A HELL OF A LOT OF TIME!!!!!!!

Tweet